Filter
Top Products
3 2
TROUBLESHOOTING
PROBLEM TROUBLESHOOTING TIP SOLUTION
Console will not turn on
Console needs a HARD reset
Batteries are low or dead
Reverse polarity
Damaged console
Remove then reinstall batteries into the console.
Replace with fresh batteries.
Insert batteries using correct polarity.
Replace console.
Crank Arms or Handles are loose
Loose hardware Using the provided assembly tools, go over the BFUB1 to make sure
all assembly hardware is tight.
No resistance
Ten sion Knob malfunction
Magnetic brake is loose
Call for service.
Call for service.
The resistance levels seem to be either too hard or too
easy
Magnetic brake has shifted Call for service.
Console button(s) do not respond to touch
Console Overlay Button(s) may have been damaged from liquids penetrating con-
sole overlay or excessive amount of cleaning solution was used.
Too much force was used operating the console buttons.
Replace console.
No Heart Rate readout on console
Heart Rate harness Remove the console and verify that the Heart Rate harness is se-
cure.
Heart Rate readout is erratic
Heart Rate contact pressure
Contact obstruction
Environmental interference
Gripping the Heart Rate contacts too tight may cause calculation
readout errors.
Tr y to maintain moderate pressure when holding onto the Heart
Rate contacts.
Remove all jewelry when using the BFUB1.
Make sure hands are not completely dry.
An exercise environment with large motors, computers, uores-
cent lighting and high power lines may cause erratic Heart Rate
readout.
Unit is unstable or rocks while in use
Levelers Make sure the unit is on a solid and level surface.
Adjust the Rear Leg End Caps to level the unit.
Speed is not calculated on the console
Console Harness
Speed Sensor
Magnet
Remove the console and verify that all connections are secure and
not damaged or pinched.
The Speed Sensor may have become dislodged or damaged.
Call for service.
The Magnet may have become dislodged or damaged.
Call for service.
The BFUB1 squeaks or makes a chirping sound
Levelers
Assembly hardware
Make sure the unit is on a solid and level surface.
Loosen all assembly hardware, grease the bolt threads then tighten
hardware.