Filter
Top Products
12
Connecting the Wireless Access Point to the Gateway
1.Connect the 12 VDC Power Supply plug on
the access point to the wall power outlet.
Use only the power adapter provided with
the product.
2. Connect the power plug to the power
receptacle on the wireless access point.
3. Connect the supplied yellow Ethernet
cable to the yellow port on the back of the
wireless access point.
4. Connect the other end of the RJ-45 Ethernet
cable to an available yellow Ethernet port on
your gateway.
1
Power LED
2
WPS
Wi-Fi Protected Setup (WPS) button
3
Wi-Fi/Paired LED
4 Ethernet Link LED
Note: This illustration may vary from the actual product.
1 Reset Restores factory default settings when held for
more than 10 seconds
2 Ethernet Connects the wireless access point to a
Port router/gateway
3 Power Connects device to the external 12 VDC power
supply
Note: This illustration may vary from the actual product.
Pairing the Wireless Access Point and Receiver
1. Press the OK button on the receiver.
2. Press the WPS button on the wireless access point.
VEN501
POWER
PAIRED
LINK
WPS
T16128
1
2
3
4
Reset
Ethernet
12VDC
T15917
1
2
3
T15918
Power
Rece
p
tacle
Reset
Ethernet
12VDC
12VDC
Gateway
Ethernet Port
RJ-45
Cable
To Wall
Power Outlet