Filter
Top Products
21
After assembly for the first time settlements
of the stock wood may occur.
Consequently we suggest that you tighten
the screws once more in the manner
described after some time. Check the the
screws before every shooting.
Cocking, loading and safety
operation
•Degrease the bolt and the interior of the
barrel without leaving lint.
•Open the reinserted bolt and pull it back
to the stop.
•Now push the bolt forward to close the
breech. A cartridge from the magazine
is fed into the chamber of the barrel.
Now push the bolt handle completely
downwards. The bolt is now cocked, the
rifle is ready for shooting.
•After firing, lift the bolt handle and pull
the bolt fully to the rear. This will cock
the bolt again and eject the empty case.
The safety is located on the side of the
receiver. It can be operated in cocked
position.
The rifle is
•safe, when the „S“ (safe) is visible but
the „F“ (fire) is covered
•ready for shooting when the „F“ (fire) is
visible but the „S“ (safe) is covered.
Unloading
For safety reasons the rifle must
immediately be unloaded if you intend to
stop shooting. Unlock and open the bolt.
This will eject the cartridge. Please also see
safety instructions for the handling of rifles
and pistols.
Magazine
•Remove the magazine from the magazine
well.
•Push the cartridges with the head first into
the magazine.
•Push the magazine into the magazine
well until you hear that the magazine
holder has caught the magazine.
•Now open the bolt completely, push it
forward and lock it. Thus the first cartridge
of the magazine is fed into the barrel, the
firing pin is cocked. The rifle is now ready
for shooting.