Filter
Top Products
3
4
To change the position of the riflescope on the weaver rail
additionally follow the steps mentioned below:
1. Unscrew the two screws, which attach the rail to the
mounting bracket.
2. Take the rail out of the groove.
3. About-face the rail in case of necessity.
4. Place the rail into another groove.
5. Fix the rail with the two screws.
NOTE: If the rail is not taken out easily, screw up tight one of screws into the threaded aperture in
the middle of a fixing projection of the rail. Continue rotation of the screw. Thus the screw will push
out a rail from a groove.
DIGITAL CONTROL
The Aries MK Trident has a simple and easy to operate one-button control and adjustment.
To turn on: Press the operation button by one short push
To turn off: Press the operation button again by one short push
To adjust reticle brightness:
After turning scope on, press and hold operation button.
Brightness will grow smoothly while the button is kept pressed.
Release the button when necessary brightness is achieved.
Press and hold the button second time for smooth decrease of brightness.
Adjustment could be easily seen if you look through the scope while adjustment.
FOCUSING
To focus your riflescope you will need to adjust the diopter first thing. Simply turn the diopter clock-
wise until it stops. Then, while looking through the diopter at a subject, slowly turn the diopter back
counter clockwise until the grain in the image is sharp.
NOTE: We suggest that you focus the diopter during daylight with the filter on.
Next, focus the front lens until the image and the grain are both sharp. When you are in the low-light
conditions and the daylight filter is off you may focus the front lens to receive a sharp image, the diopter
should not be adjusted.
NOTE: The front lens should be readjusted as you view objects at different distances.
IR ILLUMINATION
Infra-red (IR) Illuminators are common for night vision technology. The IR light greatly enhances
the performance of your Aries scope, while remaining almost totally invisible to the naked eye. In
dark environment, power up the Aries scope. Now, find a scene and examine it without the IR on
then with IR powered up. Note the difference in illumination. It is important to remember that the IR
illuminator is simply an infra red light source, and like any light source it may loose its effectiveness
over a great distance.
To fix the IR Illuminator to the riflescope screw the thumb screw on the IR into the thread on the
scope. To switch the IR on and to adjust the brightness rotate the rheostat located on the side of the
Illuminator. The changes of adjustment could be observed while looking through the scope. The IR
is off when the mark on the rheostat coincides with “0” on the scale.
NOTE: The riflescope could be equipped with digitally controlled IR.
The IR illuminator control buttons are located on its side. To switch the Digital IR illuminator on/off
press “+” and “-” buttons simultaneously. When the IR illuminator is switched on you can see the
green LED lit. By pushing the buttons “+” and “-” you may adjust the IR brightness.
The IR beam is focusable to change the field of coverage. To change the beam width slightly turn
the IR lens.
Weaver
rail
Grooves
Rail with a fixing
projection
Screws