Filter
Top Products
SCAN MODE
In Scan mode, the unit cycles through each of the display
modes (steps, distance, calories, clock, and activity time),
showing each one for five seconds. Press the cream SCAN
button to turn scanning on or off. The scan indicator (in the
bottom left-hand corner of display) will turn on to show when
you are in Scan mode.
AUTO MOVEMENT SENSOR
1. To filter out random movements, the unit remains in
standby mode until 5 continuous steps are registered. Only
then are the 5 steps calculated in, and an Active indicator
“
▲” appears on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds
the timer pauses and the unit switches to standby status
(Active indicator “▲” disappears).
RESETTING YOUR PEDOMETER
Most people prefer to reset their pedometers daily. Press and
hold the green RESET button for at least two seconds to reset
steps, distance, calories, and activity time measurements
back to zero.
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to
replace the battery. Your pedometer uses one Type LR43
(L1142) 1.5 volt alkaline battery. To replace:
1.
Insert a coin into the slot on the bottom of the case, and twist
counterclockwise to loosen the case front. Lift case front away.
2. Using a pen or other thin object, push battery sideways out
of its holder. Replace it with a new battery. The battery’s
positive (+) terminal should be FACE UP while you put it
into the pedometer.
3. Align case front over the pedometer and press gently to
snap cover back into place, starting with top.
REGISTER NOW Please return
your AE1690 Registration to the
Repair Center address in the
warranty, and we will let you know
about future products.
Email (preferred)
User
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label inside the lid of your pedometer
Attaching the Leash: Attach the pedometer to the leash by
looping the leash around the pedometer belt clip. Next, clasp
the waistband of your clothing with the attached metal clip. You
can also use a safety pin to fasten the leash to your clothing, or
loop the leash through your belt or belt loop.
VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed, it will
automatically begin to record your steps, distance, calories
burned, and activity time. Repeatedly press the yellow MODE
button to cycle through the pedometer modes:
STEPS → DISTANCE → CALORIES → ACTIVITY TIMER →
TIME OF DAY → STEPS
Press and hold the aqua colored CLOCK
button to
momentarily recall current time of day.
First, loop the
pedometer clip
Next, loop the metal
clip, then clasp clothing
Or, loop a
badge holder, then
put into pocket
(Badge holder
not included)
Or, loop a belt
or belt loop