Accusplit 790MDEC Heart Rate Monitor User Manual


 
Please note that if the stopwatch has started running (or is running), no selection for chronograph
operating modes can be made until the stopwatch has been stopped and reset.
Segmented run memory for lap/split time storage:-
A header consisting of the date/time stamp is attached to each segment to indicate the moment when you
began recording the particular timing segment. To get to this feature, press [MODE] in chronograph mode to
enter DATA mode when the stopwatch has been stopped. Records for different segments can be recalled,
read or deleted. Detailed operation in "DATA" mode is described in Data Mode section below..
Chronograph Data Recall Mode
Press [RECALL] in Chronograph mode to recall stored split/lap time memories. The mode message will be
shown up for one to two seconds as mode message display is enabled.
The split and lap time will be displayed on the upper and the middle line respectively. The lower line shows
the current stopwatch counting. During data recall, the fastest lap time will be reviewed first.
Then comes the slowest lap time by further pressing of [RECALL].
RECALL
0: 01' 12" 34
0: 00' 01" 60
0: 03' 06" 52
SPLIT
LAP
RUN
{004}
RECALL FAST
0: 00' 07" 63
0: 00' 07" 63
0: 03' 10" 16
SPLIT
LAP
RUN
{001}
RECALL SLOW
8