Accusplit 1540 Fitness Electronics User Manual


 
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset: When
displaying STEPs or DISTANCE, press yellow RESET button for
two seconds to reset STEPs and DISTANCE to zero.
E Rig! W Mr! Lv W!
 ACCUSPLIT Lftl
REGISTER NOW Please return
your AL1540 Registration to the
Repair Center address in the
warranty, and we will let you
know about future products.
Email (preferred)
User
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label inside the lid of your pedometer.
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to replace
the battery. Your pedometer uses one Type LR44 1.5 volt Alkaline
battery. To replace:
1. Insert a coin into the slot on the bottom of the case, and twist
counterclockwise to loosen the case front. Lift case front away.
2. Using a pen or other thin object, push battery sideways out of
its holder. Replace it with a new battery. The battery’s positive
(+) terminal should be FACE UP while you put it into the
pedometer.
3. Align case front over the pedometer and press gently to snap
cover back into place, starting with top.
EXCLUSIVE DISTANCE ACCURACY TIP
Maximize the accuracy of your distance measurement by:
• Walking a measured 0.5 or 1.0 mile/km. (We recommend
that you use a
1
4
-mile/400 meter track like those found at
a high school).
• Compare the DISTANCE recorded to the measured
distance. If the pedometer shows you walked LESS than
you actually did, reset your STRIDE LENGTH to a longer
setting. If the pedometer shows you walked MORE than you
actually did, reset the STRIDE LENGTH to a shorter setting.
• RESET display to zero.
• Walk the track again to test the adjustment, and re-adjust
accordingly.
• Once adjusted, DO NOT ALLOW ANYONE ELSE TO CHANGE
THE SETTING, because the Activity Pedometer is now set for
your style.
• You are now ready to walk any route, change that route freely
and still get an accurate measurement of distance for your
tness or recreation program.
ACTIVITY PEDOMETER
OPERATING INSTRUCTIONS
ACCUSPLIT®
ALLIANCE 1540