4 - 7
No. 99MBC032A
4. SETTING UP THE MEASURING CONDITIONS
4.1.2.2 Selecting and setting the function in the B1 mode
a. Setting the output function in the ready state (Guidance: )
Set whether to perform GO/NG judgment result output in the ready state.
: Neither kind of output is performed in the ready state.
: Both kinds of output are performed, even in the ready state.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between
and .
While the desired setup option is flashing, press
the
ENT
key. When the setup for this function
has been completed, the operation automatically
proceeds to the display setting in the event of Err-0.
b. Selecting the display message if Err-0 occurs (Guidance:
)
: Displays “ ”.
: Displays “ ” as the least significant digit.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and .
While the desired setup option is flashing, press
the
ENT
key. The operation automatically
proceeds to the selection of the display message at
the start of measurement.
c. Selecting the display message at the start of measurement (Guidance: )
Set the message to be displayed at the start of a single-run measurement or continuous-run
measurement.
: Displays “ ”.
: Continuously displays the previous data.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and
. While the desired setup option is
flashing, press the
ENT
key. The operation
automatically proceeds to the selection of the
averaging method.
