We just got a new PS 300 treadmill and are getting an ELV Stall Error message - any ideas?!

Asked by Dan on 01/21/2009 3  Answers

ManualsOnline posted an answer 15 years, 2 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
0 WD-40 on the worm gear, worked for me. Reset the error code: Not sure about your model, but mine is you hold the up and down together while putting on the safety magnet it will enter calibration mode, hit start. also try holding + and - and putting on the safety magnet then you can up/down through options like mph/km hours used miles used, error codes (reset), etc.
Was this answer helpful?
0 Check the wiring harness on the left handle bar. It's a pinch point. Very common for wires to be pinched in there.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.