Filter
Top Products
23. Wrap the Butterfly Cable (89) around a 3 1/2Ó Pulley
(82) as shown. Attach the Pulley and two Pulley
Covers (94) to the bracket on the
Leg Press Upright (4) with a
3/8Ó x 2 1/4Ó Bolt (99), a 3/8Ó
Washer (38) and a 3/8Ó Nylon
Locknut (42). The Pulley Covers
must be oriented as shown in
the inset drawing. Note that the
wide tab is over the stress-
point, where the Cable wraps
around the Pulley. Use this ori-
entation of the Pulley Covers in
the following assembly steps.
24. Locate one of the preassembled pairs of Pulley
Plates (31) and remove both 3 1/2Ó Pulleys (82).
Route the Butterfly Cable (89) around a 3 1/2Ó Pulley
(82) in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the Pulley Plates (31) with a
3/8Ó x 2 1/4Ó Bolt (99) and a 3/8Ó Nylon Locknut (42).
Note: The end of the Pulley Plates (31) with two
holes should be pointed downward. Orient the
wide tab on the Pulley Covers as shown.
25. Wrap the Butterfly Cable (89) around a 3 1/2Ó Pulley
(82) as shown. Attach the Pulley and two Pulley
Covers (94) to the other side of the bracket on the Leg
Press Upright (4) with a 3/8Ó x 2 1/4Ó Bolt (99), a 3/8Ó
Washer (38) and a 3/8Ó Nylon Locknut (42). Orient
the wide tab on the Pulley Covers as shown.
26. Note: The Left Arm (6) is shown removed for easi-
er part identification. Insert a 5/16Ó x 1Ó Bolt (97)
through the bracket on the Left Arm. Fully tighten a
5/16Ó Nylon Jam Nut (91) onto the Bolt.
Slide the free end of the Butterfly Cable (89) onto the
5/16Ó x 1Ó Bolt (97). Thread another 5/16Ó Nylon Jam
Nut (91) onto the Bolt, but do not fully tighten it.
Leave enough room between the two Jam Nuts
for the Cable to pivot.
12
26
23
24
25
6
End with
two holes
should be
down
42
31
4
89
94
82
94
38
99
4
42
38
99
94
89
82
94
94
99
82
89
97
91
89
42
Wide Tab
Wide Tab
94
82
Stress-point
on Cable
Wide Tab
Wide Tab