Filter
Top Products
11
23
80
Rod
28
71
76
1
1
21. Attach a Pulley Housing (94) to the indicated “U”-
channel on the 10-pound Center Resistance Bar
(44) with an M10 x 128mm Button Bolt (24), two
Pivot Bushings (74), and an M10 Nylon Locknut
(76).
Wrap the Long Cable (80) over a 90mm Pulley
(28). Attach the Pulley inside of the Pulley
Housing (94) with an M10 x 42mm Button Bolt
(71) and an M10 Nylon Locknut (76).
22. Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley, a Cable Trap (29), an M10
Washer (75), and two Finger Guards (110) to the
indicated M10 x 147mm Carriage Bolt (73) with
an M10 Nylon Locknut (76). Make sure the
Cable Trap and Finger Guards are oriented as
shown.
20. Wrap the Long Cable (80) under a 90mm Pulley
(28) as shown. Attach the Pulley, a Cable Trap
(
29), an M10 Washer (75), and two Finger
Guards (110) to the Upright (3) with an M10 x
1
27mm Button Bolt (56) and an M10 Nylon
Locknut (76). Note: The Bolt will be packaged
separately for identification. Make sure the
Cable Trap and Finger Guards are oriented as
shown.
20
21
22
80
75
110
110
29
56
28
3
76
28
74
94
74
76
76
80
71
28
80
29
76
75
110
110
73
24
44
22
104
23. Make sure there are no resistance bars under the
“U”-channels on the 10-pound Center Resistance
Bar (not shown). Have a second person pull on
the Long Cable (80) to create slack in the Cable.
Insert the end of the Long Cable (80) through the
welded tube on the indicated end of the Cross
T
ube (1
1) and then through the remaining Swivel
Arm (22). Make sure the Cable is on the indi-
cated side of the welded rod in the Swivel
Arm.
Insert the Swivel Arm (22) into the welded tube
on the Cross
T
ube (11). Secure the Swivel Arm
with an M4 x 5mm Screw (104).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel
Arm
(22) with an M10 x 42mm Button Bolt (71) and an
M10 Nylon Locknut (76).