Weider WESY41080 Home Gym User Manual


 
38. Note: The 3 1/2Ó Pulley (82) used in this step was
attached in step 36. It is shown removed for easier
part identification.
Route the Press Cable (88) around the 3 1/2Ó Pulley
(82). Make sure the Cable Trap (80) is turned to
hold the Cable in place and that the Cable is rout-
ed as shown. Tighten the 3/8Ó x 4 1/2Ó Bolt (74) and
the 3/8Ó Nylon Jamnut (43).
39. Slide a 5/16Ó Washer (20) onto a 5/16Ó x 2 3/4Ó Bolt
(55). Insert the Bolt into the Front Seat Frame (8).
Fully tighten a 5/16Ó Nylon Jam Nut (91) onto the Bolt.
Slide the end of the Press Cable (88) onto the Bolt.
Thread another 5/16Ó Nylon Jam Nut (91) onto the
Bolt, but do not fully tighten it. Leave enough
room between the two Jam Nuts for the Cable to
pivot.
40. Locate the High Cable (85)Ñthis is the longest
remaining cable. Wrap the High Cable around a
3 1/2Ó Pulley (82). Attach the Pulley to the Top Frame
(2) with a 3/8Ó x 3 1/2Ó Bolt (66), a 3/8Ó Washer (38)
and a 3/8Ó Nylon Jamnut (43). Make sure the end of
the Cable with the ball is on the indicated side of
the Pulley and that the Cable is between the
Pulley and the post.
41. Wrap the High Cable (85) around a 3 1/2Ó Pulley (82).
Attach the Pulley and a Cable Trap (80) to the Top
Frame (2) with a 3/8Ó x 3 1/2Ó Bolt (66), a 3/8Ó Washer
(38) and a 3/8Ó Nylon Jam Nut (43). Be sure that the
Cable Trap is positioned to hold the Cable in
place.
17
41
39
40
42
38
2
66
82
85
Post
85
80
38
66
2
82
43
38
82
43
80
88
91
8
88
20
55
74