Filter
Top Products
30. Route the Press Cable (88) over the indicated 3 1/2Ó
Pulley (82) attached to the Pulley Plates (31). The
Cable must be routed from the direction shown.
Refer to the inset drawing. Make sure the Cable is
between the Cable Trap (80) and the Pulley. Make
sure the Cable Trap is positioned to hold the
Cable in place as shown in the inset drawing.
Tighten the 3/8Ó x 2Ó Bolt (50) and the 3/8Ó Nylon
Locknut (42, not shown).
31. Route the Press Cable (88) around a 3 1/2Ó Pulley
(82). Attach the Pulley and a Cable Trap (80) to the
Leg Press Upright (4) with a 3/8Ó x 3 1/2Ó Bolt (66), a
3/8Ó Washer (38) and a 3/8Ó Nylon Jam Nut (43).
Make sure the Cable Trap (80) is turned to hold
the Cable in place.
32. Route the Press Cable (88) around a 3 1/2Ó Pulley
(82). Attach the Pulley and a Cable Trap (80) to the
Press Frame (12) with a 3/8Ó x 3Ó Bolt (94), a 3/8Ó
Washer (38) and a 3/8Ó Nylon Jamnut (43).
Make sure the Cable Trap (80) is turned to hold
the Cable in place.
33. Wrap the Press Cable (88) around a ÒVÓ Pulley (81).
Attach the ÒVÓ Pulley to the upper bracket on the Leg
Press Upright (4) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó
Nylon Jam Nut (43).
15
31
32
33
30
31
82
50
88
80
88
82
88
88
94
38
12
82
80
43
88
81
4
50
43
38
43
4
80
66