Filter
Top Products
23. Find the Rear Cable (87)Ñthis is the shortest
Cable. Slide one end of the Rear Cable onto the 5/16Ó
x 3Ó Bolt (92). Thread another 5/16Ó Nylon Jam Nut
(91) onto the Bolt, but do not fully tighten it. Leave
enough room between the two Jam Nuts for the
Cable to pivot.
24. See the inset drawing. Attach a 3 1/2Ó Pulley (82) and
a Cable Trap (80) to the upper hole in a Large ÒUÓ
Bracket (84) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó
Nylon Locknut (42). Make sure the Cable Trap is
inside the Large ÒUÓ Bracket. Note: This may
come pre-assembled.
Route the Rear Cable (87) through the Large ÒUÓ
Bracket (84) and the 3 1/2Ó Pulley (82). Make sure
the Cable is in the groove of the Pulley and that
the Cable and Pulley move smoothly.
25. Wrap the Rear Cable (87) around a 3 1/2Ó Pulley (82).
Attach the Pulley to the Top Frame (2) with a 3/8Ó x 2Ó
Bolt (50) and a 3/8Ó Nylon Locknut (42). The Cable
must be routed from the direction shown.
26. Thread a 1/2Ó Plain Nut (35) onto the end of the Rear
Cable (87). Place a 1/2Ó Washer (68) and a 1 1/4Ó x
1/2Ó Weight Spacer (10) on top of the Weight Tube
(25).
Thread the end of the Rear Cable (87) into the upper
end of the Weight Tube (25) until the Weight Spacer
(10) touches the Weight Tube.
Note: It is necessary to lift the Weight Tube (25) with
the Top Weight (24) slightly to thread the Rear Cable
(87) in place.
13
26
23
24
25
92
91
87
87
80
42
84
50
82
82
82
50
42
35
87
68
2
87
84
87
10
25