Filter
Top Products
13. Attach a Press Arm (7) to one side of the Press
Frame (12) with two 5/16Ó x 2 1/2Ó Bolts (39) and two
5/16Ó Nylon Locknuts (40).
Attach the other Press Arm (7) to the Press Frame
(12) in the same manner.
14. Press a 1Ó Round Inner Cap (70) into one of the
Press Arms (7). Press a 1 3/4Ó Square Inner Cap (48)
into the Press Arm.
Repeat this step for the other Press Arm (not shown).
15. Lubricate both axles on the Butterfly Frame (3).
Refer to the drawing and identify the Right Arm (5)
and the Left Arm (6) by imagining yourself sitting on
the Seat.
Press a 1 3/4Ó Square Inner Cap (48) into the upper
end of the Left Arm (6). Slide the Left Arm onto the
indicated axle. Note: Be careful not to confuse the
Left Arm with the Right Arm (5). Make sure the
upper end of the Left Arm is behind the indicated
bracket on the Butterfly Frame (3).
IMPORTANT NOTE: Before assembling the 1Ó
Retainers (45) used in this step, make sure you
thoroughly understand the step. The Retainers
can be assembled only once. If they must be
removed, you will need to order new Retainers.
Tap two 1Ó Retainers (45) and a 1Ó Round Outer Cap
(46) onto the axle. Make sure the teeth on the
Retainers bend toward the Round Outer Cap, as
shown in the inset drawing.
Attach the Right Arm (5) in the same manner.
10
13
14
15
39
7
70
40
48
12
7
7
3
Lubricate Axle
Axle
6
5
45
48
46
Bracket
45
46