Weider WESY38322 Home Gym User Manual


 
19.
Locate and open the parts bags labeled “CABLE
ASSEMBLY” and “PULLEYS.”
Locate the VKR High Cable (74), which is 82 1/4”
long and has an eyelet on one end and a thread-
ed bolt on the other end.
Attach the eyelet end of
the Cable inside of the Top Frame (6) with a 5/16” x
2 1/2” Bolt (59), two 5/16” Washers (90), and a
5/16” Nylon Locknut (86).
11
16. Lubricate a 3/8” x 3” Button Head Bolt (104) and
both sides of two Plastic Washers (56) with grease.
Attach the Right Butterfly Arm (26) to the Butterfly
Frame (47) with the Bolt, the two Plastic Washers,
two Butterfly Caps (57), two 3/8” Washers (91), and
a 3/8” Nylon Jamnut (113) as shown.
Make sure
that the recessed sides of the Plastic Washers
are fitted over the welded bushing in the
Butterfly Arm. Do not overtighten the Nylon
Jamnut; the Butterfly Arm must be able to pivot
easily.
Repeat this step with the Left Butterfly Arm (25).
17. Wet the Left VKR Arm (30) with soapy water. Slide
a Short Pad (20) onto the VKR Arm. Attach a VKR
Handle (66) to the VKR Arm with a 3/8” Washer (91)
and a 3/8” Nylon Jamnut (113). Slide an Inner Cap
w/Hole (111) onto the end of the VKR Arm.
Wet the VKR Handle (66) and the handle welded to
the Left VKR Arm (30) with soapy water. Slide 5”
Handgrips (36) onto both handles.
Repeat this step with the Right VKR Arm (31).
18. Attach the Left and Right VKR Arms (30, 31) to the
VKR Upright (5) with two 3/8” x 2 3/4” Bolts (101)
and two 3/8” Nylon Jamnuts (113).
16
26
47
113
56
104
91
57
57
91
25
CABLE ASSEMBLY
18
19
30
31
113
5
101
90
59
86
6
74
17
36
111
20
36
66
91
113
30
31
IMPORTANT: Refer to the Cable Identification
Chart on page 26 for help identifying the
cables. Do not overtighten the bolts and
nuts attaching the pulleys. The pulleys must
be able to turn freely.