Filter
Top Products
26
TROUBLESHOOTING
Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immedi-
ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the
weight pins into the centers of the weight stacks. Slack can be removed from the cables in several ways:
See drawing 1. Remove an M10 Nylon Locknut (75),
M10 x 48mm Bolt (23), 90mm Pulley (38), and Cable
Trap (37) from the Double “U”-bracket (41). Reattach
the Pulley and the Cable Trap between a set of holes
closer to the center of the “U”-bracket with the Bolt
and Locknut. Make sure the Cable Trap is turned to
hold the Cable in the groove of the Pulley.
Do not overtighten the cables. If the cables are overtightened, the top weights will be lifted off the
weight stacks.
If a cable slips off the pulleys repeatedly, it may have become twisted. Remove the cable and re-install it.
If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.
1
2
62
59
80
37
23
75
41
38
See drawing 2. To tighten the Short Cable (62),
loosen the M12 Nut (80) away from the 50mm Washer
(59). Screw the Cable into the Weight Tube (34) and
retighten the Nut against the Washer.
34