Filter
Top Products
This section explains how to adjust the weight system. See the EXERCISE GUIDELINES on page 29 for important
information about how to get the most benefit from your exercise program. Also, refer to the accompanying exercise
guide to see the correct form for each exercise. IMPORTANT: When attaching the accessories, make sure that
they are in the correct starting position for the exercise to be performed. If there is any slack in the cables
or chain as an exercise is performed, the effectiveness of the exercise will be reduced.
Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immediately.
The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
23
ADJUSTING THE BACKRESTS
To adjust the position of a Backrest (27), first turn the
Backrest Knob (48) counterclockwise several turns to
loosen it. Next, pull the Knob and slide the Backrest
Frame (16) to the desired position. Engage the Knob
into one of the holes in the Backrest Frame, and turn
the Knob clockwise until it is tight.
ADJUSTING THE CURL PAD
To use the Curl Pad (28), insert the Curl Post (19) into
the Left Leg (8). Tighten the Curl Knob (56) into the
Left Leg and the Curl Post.
When the Curl Pad (28) is not in use, remove the Curl
Knob (56) and the Curl Post (19) from the Left Leg (8).
Store the Curl Pad out of the way of the weight
system.
48
16
8
19
27
28
56
61
71
71
70
69
ADJUSTMENTS
ATTACHING THE ACCESSORIES
Attach the Lat Bar (69) to the High Cable (61) at the
high pulley station with a Cable Clip (71). For some
exercises, the Chain (70) should be attached between
the Lat Bar and the Cable with two Cable Clips.
Adjust the length of the Chain between the Lat
Bar and the Cable so the Lat Bar is in the correct
starting position for the exercise to be performed.
The Ankle Strap (not shown) or the Ab Strap (not
shown) can be attached to a cable at any of the pul-
ley stations in the same manner.