Filter
Top Products
21
59. Locate and open the parts bag labeled “SEAT
ASSEMBLY.”
Attach the Seat (26) with the serial number decal
to the Left Seat Frame (4) with four M6 x 16mm
Screws (79).
Attach the other Seat (26) to the Right Seat
Frame (not shown) in the same manner.
59
26
Wide
End
Serial Number Decal
4
79
Seat Assembly
58. Remove the M10 Nylon Locknut (75) used in
step 50.
Attach the Low Cable (63) to the M10 x 110mm
Bolt (90) in the Right Upright (5) with two M10
Washer (74), and the M10 Nylon Locknut (75).
58
74
75
90
5
63
60. Press a 38mm Square Inner Cap (44) into a
Backrest Frame (16). Attach a Backrest (27) to the
Backrest Frame with four M6 x 20mm Screws (64).
Pull the Backrest Knob (48) on the Left Upright
(6) out as far as it will go and insert the Backrest
Frame (16) into the Upright. Engage the Knob
into one of the holes in the Backrest Frame, and
turn the Knob clockwise until it is tight.
Attach the other Backrest to the Right Upright
(not shown) in the same manner. Note: The
tops of the Backrests should be closer to the
Uprights than the bottoms.
60
61. Press the two 19mm Round Inner Caps (24) into
the ends of a Pad Tube (17). Insert the Pad Tube
into the tube on the Left Leg (8). Slide the two
Foam Pads (25) onto the Pad Tube as shown.
Assemble the other Pad Tube (17) to the Leg
Lever (18) in the same manner.
61
24
24
17
17
44
6
64
64
16
18
25
25
8
27
48