Filter
Top Products
20
53. Wrap the Low Cable (63) over a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the Leg Press Arm (12) with an M10 x 120mm
Bolt (76), an M10 Washer (74), and an M10
Nylon Locknut (75). Make sure that the Cable
Trap is turned to hold the Cable in place. Do
not tighten the Locknut yet.
54. Wrap the Low Cable (63) around a 90mm Pulley
(38). Attach the Pulley to the Right Upright (5)
with an M10 x 45mm Bolt (78) and an M10 Nylon
Locknut (75).
55. Remove the M10 Nylon Locknut (75) used in
step 53.
Wrap the Low Cable (63) under a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the Leg Press Arm (12) with the M10 x 120mm
Bolt (76) used in step 53, an M10 Washer (74),
and the M10 Nylon Locknut (75). Make sure that
the Cable Trap is turned to hold the Cable in
place.
53
54
55
5
37
12
75
38
63
75
76
75
63
12
38
37
74
78
38
63
76
74
57
56. Remove the M10 Nylon Locknut (75) used in
step 52.
Wrap the Low Cable (63) over a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the Right Seat Frame (3) with the M10 x 120mm
Bolt (76) used in step 52 and the M10 Nylon
Locknut (75). Make sure that the Cable Trap is
turned to hold the Cable in place.
57. Remove the M10 Nylon Locknut (75) used in
step 51.
Wrap the Low Cable (63) over a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the Press Frame (14) with the M10 x 120mm Bolt
(76) used in step 51, and the M10 Nylon Locknut
(75). Make sure that the Cable Trap is turned
to hold the Cable in place.
56
75
37
63
3
38
76
75
37
63
38
14
76