Filter
Top Products
17
40. Wrap the Low Cable (63) around a “V”-pulley (40).
Attach the “V”-pulley and a Large Cable Trap (39)
to the center bracket on the Left Upright (6) with
an M10 x 60mm Bolt (82) and an M10 Nylon
Locknut (75). Make sure that the Cable Trap is
turned to hold the Cable in the groove of the
“V”-pulley.
42. Note: The “V”-pulley (40) attached in step 41
is not shown in this step for clarity.
Wrap the Low Cable (63) over a “V”-pulley (40).
Attach the “V”-pulley and a Large Cable Trap (39)
to the bracket on the Left Upright (6) with an M10
x 60mm Bolt (82) and an M10 Nylon Locknut (75).
Make sure that the Cable Trap is turned to hold
the Cable in the groove of the “V”-pulley.
41. Wrap the Low Cable (63) around a “V”-pulley (40).
Attach the “V”-pulley and a Large Cable Trap (39)
to the Right Fly Pivot (22) with an M10 x 91mm
Bolt (91), an M10 Washer (74), and an M10 Nylon
Locknut (75). Make sure that the Cable Trap is
turned to hold the Cable in the groove of the
“V”-pulley.
40
39. Wrap the Low Cable (63) around a “V”-pulley (40).
Attach the “V”-pulley and a Large Cable Trap (39)
to the Left Fly Pivot (21) with an M10 x 91mm Bolt
(91), an M10 Washer (74), and an M10 Nylon
Locknut (75). Make sure that the Cable Trap is
turned to hold the Cable in the groove of the
“V”-pulley.
39
41
42
40
39
39
40
6
63
82
63
6
82
75
91
40
39
63
75
21
74
91
40
39
63
75
22
74