Filter
Top Products
12
19. Press two 50mm Square Inner Caps (43) into the
Leg Lever (18).
Lubricate an M10 x 78mm Bolt (86) with grease.
Orient the Leg Lever (18) as shown and attach it
to the Left Leg (8) with the Bolt and an M10
Nylon Locknut (75). Do not overtighten the
Locknut; the Leg Lever must be able to pivot
easily.
20. Lubricate both axles on the Left Top Frame (11)
with grease.
Press a 38mm Square Inner Cap (44) into the
Left Fly Pivot (21). Slide the Left Fly Pivot onto
the indicated axle on the Left Top Frame (11). Set
two 25mm Retainer Rings (53) on a 25mm Round
Outer Cap (47). Make sure the teeth on the
Rings are toward the Cap, as shown in the
inset drawing. Tap the Retainer Rings and Outer
Cap onto the axle. Repeat with the Right Fly
Pivot (22).
19
20
86
18
75
43
43
8
47
11
Lubricate
Small
Slot
21
44
53
Axle
22
53
47
Axle
18. Press a 50mm Square Inner Cap (43) into a
Press Arm (15). Press two 25mm Round Inner
Caps (65) into the Press Arm.
Wet the handles on the Press Arm (15) with
soapy water. Slide two Grips (68) onto the han-
dles.
Attach the Press Arm (15) to the Press Frame
(14) with two M10 x 70mm Bolts (87) and two
M10 Nylon Locknuts (75).
Attach the other Press Arm (15) to the Press
Frame (14) in the same manner.
18
43
15
65
75
15
14
87
68
21. Press a 50mm Square Inner Cap (43) into a
Butterfly Arm (20).
Wet a Fly Handle (66) and the inside of a Long
Foam Pad (33) with soapy water. Slide the Foam
Pad onto the Handle.
Attach a Fly Handle (66) to the Butterfly Arm (20)
with two M10 x 25mm Button Screws (60) and
two M10 Washers (74).
Repeat this step with the other Butterfly Arm
(not shown). Make sure that the Fly Handle is
oriented as shown in step 22.
20
66
33
60
74
43
21