Filter
Top Products
10
If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated Console Back Screw (67) and the Access
Door (70) from the left side of the Console Back (69).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (69). Hold the re-
ceiver so the small cylinder is oriented as shown.
Attach the receiver to the plastic posts on the Access
Door (70) with the two included small screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (70) with the Console Back Screw (67). The
other wires included with the receiver may be discarded.
A
70
69
Small
Cylinder
67
Wire
Small
Screws
12. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking
belt (see page 26). To protect the floor or carpet, place a mat under the treadmill.
11. Place the treadmill in the storage position (see HOW TO
FOLD THE TREADMILL FOR STORAGE on page 23).
Center the Frame (48) between the Uprights (73, 74).
T
ighten the Upright Bolts (72) in the lower ends of the
Uprights (73, 74).
73
11
74
48
72
72