Filter
Top Products
22
ATTACHING AND REMOVING THE SEAT
To attach the Seat (13), set the bracket on the Front
Seat Frame (36) onto the indicated pins on the Front
Upright (42). Attach the Seat Frame to the Front
Upright with the 5/16Ó x 2 3/4Ó Carriage Bolt (14),
3/16Ó Flat Washer (8) and the Seat Knob (40).
For some exercises, the Seat (13) must be removed.
First, be sure that the chain is not attached to the leg
lever. Next, remove the Seat Knob (40), 3/16Ó Flat
Washer (8) and the 5/16Ó x 2 3/4Ó Carriage Bolt (14)
from the Front Seat Frame (36). Lift the Front Seat
Frame off the Front Upright (42).
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (29), the seat must be attached
to the Front Upright (42) (see ATTACHING AND
REMOVING THE SEAT above).
Attach one end of the Chain (52) to the Low Cable
(23) with a Cable Clip (53). Attach the other end of
the Chain to the Eyebolt (35) with a Cable Clip.
ADJUSTING THE LEG PRESS PLATE
Remove the Press Pin (97) from the Leg Press Plate
(95) and the Leg Press Arm (96).
Align the welded tubes on the Leg Press Plate (95)
with the desired set of holes in the Leg Press Arm
(96). Re-insert the Press Pin (97) through the welded
tubes on Leg Press Plate and the holes in the Leg
Press Arm.
36
13
40
8
14
Pin
42
29
53
35
23
42
97
96
95
53
52
Welded
Tube