Filter
Top Products
16
32. Wrap the Military Press Cable (72) around a 3
1/2Ó Pulley (15). Attach the Pulley and a
Cable Trap (66) to the Pivot Arm (80) with the
3/8Ó x 5Ó Bolt (101). Be sure the Bolt is on
the side shown, and that the Cable Trap is
positioned to hold the Cable in place. Do
not attach a locknut yet.
See the inset drawing. Wrap the Military
Press Cable (72) around a 3 1/2Ó Pulley (15).
Attach the Pulley and a Cable Trap (66) to the
upper hole in the Long ÒUÓ-Bracket (57) with a
3/8Ó x 2Ó Bolt (12) and a 3/8Ó Nylon Locknut
(21). Be sure that the Cable Trap is inside
the Long ÒUÓ-Bracket, the Cable is in the
groove of the Pulley, and that the Cable
and Pulley move smoothly.
Wrap the Military Press Cable (72) around
another 3 1/2Ó Pulley (15). Attach the Pulley
and a Cable Trap (66) to the Pivot Arm (80)
on the other side of the 3/8Ó x 5Ó Bolt (101),
with a 3/8Ó Nylon Locknut (21). Be sure that
the Cable Trap is positioned to hold the
Cable in place, and that the Cable is rout-
ed as shown.
33. Wrap the Military Press Cable (72) around a 3
1/2Ó Pulley (15). Attach the Pulley and a
Cable Trap (66) to the Leg Press Upright (56)
with a 3/8Ó x 2Ó Bolt (12) and a 3/8Ó Nylon
Locknut (21). Be sure the Cable Trap is
positioned to hold the Cable in place.
34. Lay the Military Press Cable (72) over a 3 1/2Ó
Pulley (15). Attach the Pulley and both Pulley
Covers (77) to the Leg Press Upright (56) with
a 3/8Ó x 3 3/4Ó Bolt (88), two 3/8Ó Flat
Washers (9), and a 3/8Ó Nylon Jam Nut (99).
Make sure that the Cable (72) is between
the Pulley (15) and the post. Be sure that
the Cable and Pulley move smoothly.
The Pulley Covers (77) must be turned so
that the large tabs face toward the weight
system. See the inset drawing.
32
CABLE ASSEMBLY
101
57
21
66
80
15
66
21
57
12
15
66
33
56
72
12
15
66
21
34
72
88
9
15
77
56
Post
9
99
72
Large tabs
must be in
this location