Filter
Top Products
32
STAR
TRAC
S
SERIES
BIKES
O
WNER
’
S
M
ANUAL
and cooldown.
WGT 1 (lb)
1 (kg)
500 (lb)
226 (kg)
155 (lb)
70 (kg)
Default Weight (to user). Typical weight in lb (UNx = UNE) or kg (UNx =
UNM).
Lxx N/A N/A LEN Language. Display language; either LEN (English), LGE (German), LSP
(Spanish), LDU (Dutch), LPO (Portuguese), LFR (French), LIT (Italian), LSW
(Swedish) or LKA (Katakana).
LOE OFF ON OFF Lockout Enable. Enables/disables lockout function.
LOI 001 999 001 Lockout ID. Lockout override identification number.
MAINTENANCE MODE
Your Service Representative may need to check accumulated data about the past usage of your bike, test its display controls, or
investigate error messages. For these reasons, your bike is equipped with a Maintenance Mode. The Maintenance Mode includes
all of the items available through Manager Mode, plus additional items for Service and Diagnostic use. To enter Maintenance
Mode:
1. Press and hold the , and keys together.
2. A beep will sound and “MAINTENANCE SETTINGS” will scroll once across the PROFILE Window.
3. Release all keys. “SN” will display in the PROFILE Window; the associated numeric value for the parameter will display
in the DISTANCE Window.
NOTE: The system will automatically exit MAINTENANCE SETTINGS if no key is pressed for 30 seconds.
The following keys are used to modify MANAGER SETTINGS:
Increase and Decrease Level Keys: Display the next (Increase) and previous (Decrease) parameters. Keys will
repeat if held.
Numeric Keypad: Facilitates entry of the desired value for the displayed parameter. These keys do not save the
new value – see OK Key below.
OK Key: Updates (saves) the value of the displayed parameter in Flash memory. “UPDATING” will scroll once
across the PROFILE Window while the update is in process. When the update is complete, the PROFILE Window will
show the new value for the parameter.
NOTE: To exit maintenance SETTINGS without saving any values or settings, press the QUICK START key.
NOTE: Unless otherwise specified, the Item (parameter) name is shown in the PROFILE Window, and the value of the parameter is
shown in the DISTANCE Window.
The items that you may display and change with the previous keys are:
Item
Lowest
Value
Highest
Value
Default
Value
Meaning
SN 0 9999 N/A Serial Number. S Series Bike serial number (set by factory).
DSW 1.0 99.99 N/A Display Software. Display panel software version number (set by factory).
NOTE: Software checksum value is displayed in CALORIES Window.
OHR 0 9999 0 Operating Hours. Total operating hours.
DST 0 9999 0 Distance. Total distance ridden in miles or kilometers, based on current UNx
setting.
UNx UNE UNM UNE Units. UNE (English) = units of pounds, miles, feet, inches
UNM (Metric) = units of kilograms, kilometers, centimeters
NOTE: Current Value is shown in PROFILE Window.
TIM 5 99 99 Time. Maximum time in minutes allowed for a program, excluding warm-up
and cooldown.
WGT 1 (lb)
1 (kg)
500 (lb)
226 (kg)
155 (lb)
70 (kg)
Default Weight (to user). Typical weight in lb (UNx = UNE) or kg (UNx =
UNM).