Stamina Products 15-9200 Bicycle User Manual


 
10
SET UP INSTRUCTIONS
Place the CPS 9200 Indoor Cycle in the area where it will be used. It is recommended that the CPS 9200
Indoor Cycle be placed on an equipment mat. The CPS 9200 Indoor Cycle is approximately 50 inches
long (max.) x 18 3/8 inches wide x 42 5/8 inches tall (max.). An area 4 feet wide x 6 feet long is required for
safe operation of the CPS 9200 Indoor Cycle. Make sure that adequate space is available for access to and
passage around the CPS 9200 Indoor Cycle.
Adjust the STANDS(51) under the FRONT and REAR STABILIZER(3, 4) so that the CPS
9200 Indoor Cycle sits on the floor without rocking. Refer to the instructions below the
illustration.
The CPS 9200 Indoor Cycle has a pair of WHEELS(49) on the FRONT STABILIZER(3). Lift
up the REAR STABILIZER(4) to move the CPS 9200 Indoor Cycle.
LEVELING:
MOVING:
FUNCTION INSPECTION:
Visually inspect the CPS 9200 Indoor Cycle to verify that assembly is as shown in the above illustration.
Check the function of the CPS 9200 Indoor Cycle by turning the crank slowly through one complete revolution
to verify that the drive train functions properly. Adjust the TENSION KNOB(34) to verify that the adjustable
tension is working properly.
Locate and read the WARNING LABEL(70) on the CPS 9200 Indoor Cycle. Make sure that all
users read the WARNING LABEL(70).
CAUTION:
Loosen the NUTS(M8x1.25)(67) until they touch
the STANDS(51). Adjust the STANDS(51) for
leveling. Tighten the NUTS(M8x1.25)(67)
securely against the STABILIZERS(3, 4) to lock
the STANDS(51) in position.
EQUIPMENT MAT
(not included)