Filter
Top Products
ASSEMBLY INSTRUCTIONS
10
STEP 9
Install two AA batteries into the METER(31). Two batteries are included. See page 13 for detailed battery
installation instructions. Connect the SENSOR WIRE(30) and the PULSE PLUG WIRE(38) to the
EXTENSION WIRES on the METER(31). Press the METER(31) into the hole in the COVERS(33, 34).
STEP 8
NOTE:
The RIGHT PEDAL(37) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(37) has
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(36) has L stamped on
the end of the pedal shaft. The LEFT PEDAL(36) has left hand threads and is tightened by turning
counterclockwise.
Thread the RIGHT PEDAL(37) into the right side of the CRANK(7) as shown. Tighten the pedal securely.
Do the same to attach the LEFT PEDAL(36) to the left side of the CRANK(7).