Filter
Top Products
SPEED display--This display shows the current speed of the walking belt.
PULSE display--This display shows your heart rate. To use the pulse
display, first stand on the foot rails and place your thumb on the pulse
sensor as shown. The pulse sensor is pressure-activated. Fully press
down the sensor. Do not press too hard, or the circulation in your
thumb will be restricted, and your pulse will not be detected. Next,
slightly raise your thumb until the heart-shaped indicator next to the
PULSE display flashes steadily. Hold your thumb at this level. After 5
to 10 seconds, your pulse will be displayed. If the pulse displayed
appears to be too high or too low, or your pulse is not displayed, lift
your thumb off the sensor and allow the display to reset. Press down
again on the sensor as described above. Make sure that your thumb is
positioned as shown, and that you are applying the proper amount of
pressure to the sensor. Try the pulse sensor several times until you
become familiar with the pulse sensor.
Another method of finding your pulse is to gently press down on the sensor until the top of the sensor is just
above the surface of the console. Do not press too hard, or the circulation in your thumb will be restricted,
and your pulse will not be detected. After a few seconds, the heart-shaped indicator will flash each time your
heart beats. After another 5 to 10 seconds, your pulse will be displayed, if your pulse is not displayed, make sure
that your thumb is positioned as shown, and that you are applying the proper amount of pressure to the sensor.
Remember to stand still while measuring your pulse.
TURNING OFF THE POWER
To turn off the power, remove the safety key from the console. Store the safety key in a secure location.
10