Sears 831.288720 Home Gym User Manual


 
6
6. Attach the Seat (12) to the Seat Carriage (4) with four
M6 x 16mm Button Screws (57).
8. Identify the Left Pedal (24), which is marked with an
“L.” Using an adjustable wrench, firmly tighten the
Left Pedal
counterclockwise
into the left arm of the
Crank (27). Tighten the Right Pedal (not shown)
clock-
wise
into the right arm of the Crank. Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten the
Pedals. For best performance, the Pedals must be
kept tightened.
Adjust the Left Pedal Strap (65) to the desired position
and press the end of the Strap onto the tab on the Left
Pedal (24). Adjust the Right Pedal Strap (not shown) in
the same way.
27
24
Tab
65
8
7. The Console (16) requires two AA batteries (not includ-
ed). Alkaline batteries are recommended. Refer to the
inset drawing. Remove the battery cover from the back
of the Console, and insert two AA batteries into the
Console. Make sure that the negative ends of the
batteries (marked “–”) are touching the springs in
the Console. Reattach the battery cover.
Next, plug the Reed Switch Wire (43) into the back of
the Console (16). Carefully slide the Console onto the
indicated tab on the Frame (1). Note: The Console is
held by friction; it does not snap into place.
Press the Resistance Knob (14) onto the Resistance
Control (13).
1
43
14
13
16
7
6
12
57
57
57
4
9. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra hardware may be left over. Place a mat beneath the exercise cycle to protect the floor.
16
Batteries
Battery
Cover