ProForm No. 831.290880 Home Gym User Manual


 
Inspect and tighten all parts of the AIR WALKER XT
regularly. Replace any worn parts immediately.
The AIR WALKER XT can be cleaned with a soft,
damp cloth. Keep liquids away from the electronic
monitor. Keep the monitor out of direct sunlight or the
display may be damaged. Remove the battery when
storing the AIR WALKER XT.
REPLACING THE BATTERY
If the display of the electronic monitor becomes dim,
or if the monitor does not function properly, the battery
should be replaced. To replace the battery, refer to
assembly step 3 on page 4.
HOW TO ADJUST THE REED SWITCH
If the electronic
monitor does not
display correct
information, the
reed switch
should be
adjusted. The
reed switch is
located below the
electronic monitor
(see the drawing
at the right).
Loosen the
indicated screw,
slide the reed switch to the side slightly, and retighten
the screw. Make sure that the reed switch does not
hit the indicated magnet when the AIR WALKER
XT is in use. Repeat until the modes display correct
information.
HOW TO FOLD THE AIR WALKER XT FOR
STORAGE
When the AIR WALKER XT is not in use, it can be
folded to the storage position. To fold the AIR
WALKER XT, first remove the lock knob and washers
from the left leg. Keep the lock knob and washers in a
secure place. Next, fold the uprights against the
frame. Place the AIR WALKER XT in a location
where it cannot fall.
8
STORAGE AND TROUBLE-SHOOTING
Frame
Upright
Lock
Knob
Magnet
Screw
Reed Switch