Filter
Top Products
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish assembly.
• The underside of the walking belt is coated with
high-pedormance lubricant. After shipping, there
may be some lubricant on fop of the walking belt
or on the shipping carton. This is normal. If there
is lubricant on top of the walking belt, wipe it oN
with a soft cloth and a mild, non-abrasive cleaner.
• To identify small paris, see page 6.
• Assembly requires the following tools:
the included hex keys |
one Phillips screwdriver
scissors 8=_
• To avoid damaging parts, do net use power tools,
1. Make sure that the power cord is unplugged.
Remove and discardthetwo screws(A) and the
shipping bracket (B) from the r_ghtside ofthe
Base (74). 3"hen,remove and discard thescrews
and shipping bracket (not shown)from the left
side of the Base.
74
2. With the help of a second person, tip the tread-
mill onto its left side. PaPally pivot the Base (74)
to help stabUze the treadmill.
Pull the Upright Wire (63) and the ground wire
through the indicated hole in the Base (74).
Attach the groundwire te the Base (74) witha#8
x 1/2" Ground Screw (1).
See the inset drawing, Cut the plastic tie near
the Upright Wire (63). Be careful not to dam-
age the Upright Wire,
2 63