Filter
Top Products
TROUBLESHOOTING
Most treadmill prob{ems can be solved by following
the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, see the front cover of this manual
SYMPTOM: The power does not turn on
Make sure that the power cord is plugged into a
surge suppressor and that the surge suppressor is
plugged into a properly-grounded outlet (see page
13). Use or, ly a single-outlet surge suppressor that
meets all of the specifications described on page
13. IMPORTANT: The treadmill is not compat-
ible with GFCl-equipped outlets and may not be
compatible with AFCl-equipped outlets.
b. After the power cord has been plugged in. make
sure that the key is inssded into the console.
Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
power switch, wait for five minutes and then press
the switch back in,
Tripped
Reset
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug if, wait for five
minutes, and then plug it back in.
c. Remove the key from the consols, and then
reinsert it.
d, If the treadmill still wilt not run, please see the front
cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a, 3he console features a display demo mode, de-
signed to be used if the treadmill is displayed in a
store. If the displays remain lit when you remove
the key, the dome mode is turned on. To turn oil
the demo mode, hold down the Stop button for a
few seconds. Ifthe displays are still lit, see THE
INFORMATION MODE on page 18 to turn off the
dome mode.
SYMPTOM: The displays ofthe console do not
function properly
a. RemovethekeyfromtheconsolsandUNPLUG
THE POWER CORD. Next, remove the five indi-
cated #B x 3/4" Screws (4).
Carefully lift the Motor Hood (48) upward_ and then
slide it forward and off. Make sure that the Motor
Hood does not get caught bythe tabs on Ibe sides
of the Motor Hood.
2O