Filter
Top Products
4
ASSEMBLY
A
ssembly requires two persons.
P
lace all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys and your own phillips screwdriver and rubber
mallet .
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly.
The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 21.
The number after the key number is the quantity used in assembly.
Note: Some small parts may have been
preassembled. If a part is not in the parts bag, check to see if it is preassembled.
M8 x 56mm Button Screw (83)–4
M8 x 79mm Bolt Set (65)–2
M10 x 108mm Button Screw (70)–2
M10 Split
Washer (73)–2
7.6mm Spacer
(47)–2
M4 x 16mm
Round Head
Screw (69)–4
M8 Split
Washer (85)–4
M4 x 16mm
Screw (94)–2
M8 x 44mm Button
Screw (84)–8
1. Identify the Front Stabilizer (8). While another person
lifts the front of the Frame (1) and holds the Pedal
Legs (4, 5) in the position shown, attach the Front
Stabilizer to the Frame with four M8 x 44mm Button
Screws (84) and a Support Plate (64).
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (not shown) to the Frame
in the same way.
1
8
4, 5
1
64
84
84