Filter
Top Products
8
6. Press the two Upright Covers (75) onto the Upright Base
(85). Attach each Upright Cover with a 3/4” Screw (7). Be
careful of the the wires in the right upright.
85
75
7
85
75
Wires
7
6
7. Cut the tie securing the Wires to the Upright Base (85).
Have a second person hold the console assembly near the
Upright Base (85). Connect the Upright Wire Harness (73)
and the Pulse Wire (74) to the wires extending from the
console assembly. The connectors should slide together
easily and snap into place. If they do not, turn one con-
nector and try again. Insert the connectors into the
Console Assembly.
Connect the Upright Ground Wire (113) to the ground wire
extending from the console assembly. Make sure that the
wires are fully inserted into each other. Insert the ground
wires into the Console Assembly.
85
73
Console
Assembly
Ground
Wire
74
113
7
73
74
5. Slide the two Upright Covers (75) onto the ends of the
Pulse Bar (69). Align the holes in the lower ends of the
Pulse Bar with the holes in the Upright Base (85).
Cut the tie securing the Pulse Wire (74) to the Upright
Base (85). Connect the Pulse Wire to the Pulse Bar Wire
(79).
The connectors should slide together easily and
snap into place. If they do not, turn one connector
and try again. Insert the wires down into the right side of
the Upright Base (65).
Hold the Pulse Bar (69) against the Upright Base (85). Do
not drop the Pulse Bar into the Upright Base. Attach the
Pulse Bar to the Upright Base with the four Pulse Bar
Bolts (66) and four Star Washers (67). Be careful not to
pinch the wires. Start all four Pulse Bar Bolts before
tightening them.
Slide the Upright Covers (75) over the Pulse Bar Bolts
(66).
85
85
75
69
74
79
66
67
66
5
67
79
74