Filter
Top Products
SM63 Unpacking & Assembly Instructions
5
Figure 3. Set the weight stack cubes.
2. Bolt on the teardrop pulley assemblies above the benches (see Figure 4) on both
cubes using two 3/8” x 2-3/4” hex head bolts. Include the 3/8” flat washer, end cap
washers, end caps and 3/8” Nyloc (locknut). Use the bolt configuration shown in
Figure 5. You may wish to use a pinch bar to align the bolt holes.
Figure 4. Bolt on the teardrop pulleys.