Filter
Top Products
SM63 Unpacking & Assembly Instructions
13
INSTALLING THE CABLES
The SM63 uses six cables. There are two different types of cable used on the SM63. They
are:
1. Adjustable crossover cables (ball end cables) (3).
2. Lat pulldown and tricep cables (3).
The lat and tricep cables can be identified by their short length, the adjustable crossover
cables can be identified by the ball on the end of the cable. The routings for these cables are
shown in Figures 16, 17, 18 and 19 below.
NOTE: YOU MUST REMOVE ALL PULLEYS TO ROUTE THE CABLES.
USE A 9/16” COMBINATION WRENCH AND SOCKET TO DO THIS
(SEE FIGURE 16). YOU MAY WISH TO REMOVE THE SHOULDER
BOLTS (FIGURE 16 RIGHT SIDE) BY USING A 3/8” COMBINATION
WRENCH AND A 1/8” HEX KEY WRENCH. WHEN YOU HAVE
ROUTED THE CABLES, REPLACE ALL PULLEYS AND PLACE
END CAPS ON NUT AND BOLT ENDS. YOU MAY NEED TO PRY
THE PULLEY HOUSINGS OPEN TO REPLACE THE PULLEYS.
Figure 16. Removing the pulley bolts.