Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY S T E P 5
PRE-ATTACHED
BOLT AND WASHER
PRE-ATTACHED
WASHERS
CONSOLE MAST
LOWER HANDLEBAR
A S S E M B LY S T E P 4 ( C O N T I N U E D )
A) HARDWARE BAG FOR STEP 4 (continued).
B) Attach the PEDAL ARM COVER to the right PEDAL ARM using SCREW (L).
C) Repeat on the other side.
D) Attach the ROLLER WHEEL COVER to the right PEDAL ARM using SCREW (M).
E) Repeat on the other side.
F) Insert GUIDE RAIL END CAP into right GUIDE RAIL socket
E) Repeat on the other side.
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLTS & WASHERS from CONSOLE MAST.
B) Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.
C) Repeat on other side.
D) (For 2.3E only) Attach WATER BOTTLE CAGE using PRE ATTACHED SCREWS.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
WARNING
ROLLER WHEEL COVER
PEDAL ARM COVER
PEDAL ARM
SCREW (M)
SCREW (L)
GUIDE RAIL END CAP
PRE ATTACHED SCREWS
WATER BOTTLE CAGE
2.3E-4.3E_Rev.1.9.indd 10-11 10/4/06 2:27:29 PM