Filter
Top Products
Belt and Cable Tension:
Referring to the Owners Manual, when belts or cables are used check all bolts attachments to be •
sure they are properly attached.
Check slack in cables and re-adjust cable tension if needed.•
Seat Sleeves, Guide Rods:
Wipe down adjusting tubes with a dust free rag before applying lubricant.•
Lubricate seat sleeves and Guide Rods with a Silicon or Teflon based lubricant spray.•
Linear Bearings:
Referring to the Owners Manual carefully disassemble the bearing from its housing and place a •
finger full of light grease (lithium, super lube, etc.) into the inside of the bearing. Using your
finger, press the grease into the ball-bearings and their tracks. repeat until the ball-bearing
tracks are full of grease. Insert the shaft back into the bearing and wipe off excess grease.
GENERAL MAINTENANCE INFORMATION
PLEASE KEEP THIS FOR YOUR RECORDS
(CONTINUED)
OWNER'S MANUAL
RS-1101 ASSEMBLY
PAGE 24