Filter
Top Products
The FLICKER FLASHER GAME contains six different action-packed
games that require skill and determination to win! Compete against the
FLICKER FLASHER or your friends by following and responding to the
light and sound commands. Hold it or Pass it to a friend ... follow the
flashing lights while the Rugrats music gets faster and faster, keep up
or you're out of the game! Use your wits and strategy skills to out-think
your opponent and stay in the game.
INSTALLING THE BATTERIES
NOTE: Battery installation should be done by an adult. Always install
the batteries correctly according to the positive (+) and negative (-) signs
on the batteries.
1. Open the battery compartment
door using a Phillips screwdriver.
2. Insert 3 "AA"/LR 6 batteries.
Be sure to match the "+" and
"-" signs as shown.
3. Close the battery compartment
door and replace the screw
using a Phillips screwdriver.
CAUTION
To ensure proper function and avoid battery leakage:
• Do not mix old and new batteries.
• Do not mix alkaline, standard or rechargeable batteries
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity, and follow the toy and battery manufacturer's
instruction.
• Exhausted or dead batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Remove the batteries if you won't be using the unit for a long period of time.
FUNCTION BUTTONS
ON/OFF button - press this button to
turn ON the unit and to turn OFF the
unit. Unit will shut off automatically
after 3 minutes of inactivity.
SOUND button - press this button to
turn OFF the sound. Press the button
again to turn ON the sound.
SELECT button - press this button to
select a game and the number of
players. Press this button at any time
during a game to select another game
and to change the number of players.
START button - press this button to
start each of the six games.
RUGRATS CHARACTER buttons - press one of the six Rugrats character
buttons to compete in each of the six games. The button numbers are
assigned as follows:
Tommy character ................................... button number 1
Angelica character .................................button number 2
Chuckie character ..................................button number 3
Lil character ........................................... button number 4
Phil character .........................................button number 5
Reptar character .................................... button number 6
SELECTING A GAME/NUMBER OF PLAYERS
When you are selecting a game and choosing the number of players,
you will hear a Rugrats character voice each time you press one of the
six character buttons.
To choose a game and number of players, press the SELECT button
and then press the character button for the game you want to play (game
numbers are listed above). For example, if you want to play CHASER,
game #6, press the SELECT button and then press the number 6 button
(Reptar).
NOTE: After you select a game, you must choose the number of players
before you begin the game - the unit will not function properly if you
choose a game and press START without choosing the correct number
of players.
Press the SELECT button again (after choosing the game) and then
press a character button for the number of players. For example, if there
are 4 players in the game, press the SELECT button and then press the
number 4 button (Lil).
Press the START button after you have selected the game number and
the number of players. You will hear Angelica's voice say "I'm almost
ready to start" and the game will begin.
If you have entered an incorrect button press, the unit will respond with
BEEP tones. An incorrect button press can be the result of one of the
following:
1. Choosing an incorrect number of players for the game selected
2. Pressing the START button before you have selected the game and
number of players
If you hear the BEEP tones, begin again by pressing the SELECT button,
choose the game number, press the SELECT button again, choose the
number of players, and press START to begin.
SCORING
The unit will keep count of the number of button presses while playing
the FOLLOW THE LEADER, CODE BUSTER and CHASER games.
There is no scoring in the PASS IT FAST, CATCH ONE and LUCK OUT
games. Compete with your friends to see who can get the best score.
Try to beat your own best score!
The character buttons will display your score at the end of the game.
Each non-flashing, steady button represents 10 points and each flashing
button represents one point for each flash. For example, if your score
is 12, then one button will stay steady and one button will flash twice.
If your score is 47, then four buttons will stay steady and one button will
flash 7 times. If your score is 6, then one button will flash 6 times.
GETTING STARTED
1. Press the ON button.
2. After the introduction phrase "Come On! Let's Play," press the
SELECT button and select a game.
3. Press the SELECT button again and select the number of players.
4. Press the START button when you are ready for the fast-action fun
to begin.
5. Press the SOUND button at any time to switch the sound on or off.
AGES 5 & UP
MODEL 09-704
INSTRUCTIONS
®
Electronic Memory
and Reaction Game
Insert
3AA/LR6
Batteries
Phillips
Screwdriver
ON/OFF
START
SELECT
SOUND