Filter
Top Products
6
• Push the net sleeves down on the side tubes.
• Fit two lock nuts, rounded side out, into the hex hole in the inside of each
side tube assembly.
• Insert a screw into the outside hole in each side tube assembly.
• While holding the lock nut in place, tighten the screw. Repeat this
procedure to fasten the other screw.
• Fit the ends of the tubes together.
• Fit a lock nut, rounded side out, into the hex hole on the inside of the
tube assembly.
• Insert a screw through the hole in the outside of the tube assembly.
• While holding the lock nut in place, tighten the screw.
• Insert the inflation pin into the ball.
• Attach the pump (not included) to the pin.
• Inflate the ball to a circumference of 15
1
/
2
" (39 cm), until firm.
Do not over-inflate.
• After inflating the ball, remove the pin. Store the pin out of the reach of
children for future use.
Assembly is now complete.
Sleeves on
Side Tubes
Rounded
Side
Rounded
Side
12
13
14
ASSEMBLY
ASSEMBLY
ASSEMBLY