Filter
Top Products
Component List:
1 Tent 2 Tent Poles 1 Carry Bag
1 Stake Bag W/Stakes 1 Rain Fly
4 Brim Rods 1 Pole Bag 6 Pull Out Cords
1 Sewn-In Gear Loft 1 Divider
NOTE:
•
Although it is possible to pitch this tent alone, it
is faster and easier with two people.
• Do not drop tent bag or pole bag on its end. Do
not bounce tent bag on its end to get the tent out.
These actions may cut the shock-cord and/or
damage the pole ends.
• The tent clip webbing is now color coded for
even easier set-up. Just slide one pole through one
color.
1. Unroll and unfold the tent on the ground. Separate
the rest of the components and place to one side.
Open the door before pitching the tent. Do not stake
the tent down (however, in windy conditions, stake
down one corner that faces into the wind).
2. Assemble both of the shock-corded tent poles.
Keep the pole sections from snapping together, as
this can damage the ends.
Note: Make certain each plain end has been
properly seated into the metal ferrule.
3. Insert the assembled pole through both sleeves
from A to B. Insert the second pole through the
sleeves from C to D, forming an X across the tent.
See Fig.1
4. At A, insert the tent corner pin into the end of the tent pole ferrule.
At B, grasp the tent corner pin in one hand, the tent pole in the other.
Arch the pole to raise the tent and place the pin into the end of the
pole. Repeat this with the second pole from C to D.
See Fig.2 and 3.
5. Start at the bottom and attach all the clips to
the poles to create a freestanding tent. Place it in
the desired location. See Fig.4 and 5.
6.. Stake the tent down through the corner
rings. Stake the opposite corners while
applying tension to smooth the floor wrinkles.
See fig 6.
Important: In strong winds, tie extra guy out
cords (not provided) to the storm loops on
the fly. Stake these out securely.
ASSEMBLY
INSTRUCTIONS
FOR THE
TETRAGON 1210
REV.E 4-09
A
A
B
B
D
D
C
C
7. Drape the fly over the tent
so that the brim rod sleeves
are above the doors and
windows and the vestibule is
over the front door. Slide the
brim rods into the sleeves.
See fig 7.
10. Reach under the fly and insert the brim rod
tips into web grommets to tension the rod and
create an arch over the door. Repeat over the
remaining door and windows. See fig 10.
11. Pull out and stake down the two front loops
of the fly vestibule. See fig 11.
8. Reach under the fly
and wrap the hook and
loop straps around the
poles to secure the fly
to the tent frame.
See fig 8.
9. Fasten the shock
corded J-hook, at each
of the corners of the
fly, to the stake out
rings on corners of the
tent. See fig 9.
Your tent is now ready for use.
fig 1
fig 3
fig 4
fig 6
fig 2
fig 7
fig 8
fig 9
fig 10
fig 11
fig 5