Turn on your equipment
Connect the projector
to your notebook
Follow these instructions to connect the projector to your
notebook. For other setup options, see your User’s Guide.
Epson
®
PowerLite
®
830p
Quick Setup
Power cord VGA computer cable
1
If you’ve turned on your notebook and you don’t see an image,
press the Source Search button on the projector to select the
image source.
NOTE: If you still see a blank screen or have other display problems,
see the troubleshooting tips on the back of this sheet.
2
Press the Focus buttons to sharpen the image. Press the Zoom buttons
to reduce or enlarge the image.
3
If your image looks like or , you’ve placed the projector off
to one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely, or press the or
Tracking buttons on the projector.
4
If your image looks like or , press the or Sync buttons
on the projector.
Zoom
to adjust the
image size
Focus
to sharpen
the image
A
djust the image
CAUTION: Before unplugging the projector...
Shut down the projector properly:
1. Press the Power button twice. Let the projector cool while
the Power light flashes orange (about 30 seconds).
2. Once the light stops flashing and stays on, it’s safe to unplug
the projector.
Select an
image source
Power button
Power light
1
Locate the required cables:
2
Connect the computer cable to
the Computer 1/Component
port on the projector.
3
Connect the other end to your notebook’s video-out
or monitor port.
NOTE: If your notebook has a DVI connector, you need to either
use a DVI-to-VGA adapter with the included computer cable (see
your computer’s documentation), or purchase an optional DVI
cable (for a higher-quality image). See your User’s Guide.
4
Connect the power cord to the
projector, then plug the other end
into a grounded electrical outlet.
