Filter
Top Products
28
72
50
USING THE LEG LEVER LOCK
When using the low pulley station, engage the Leg
L
ever Lock (47) onto the Leg Lever (15) tube.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cables before resistance is felt,
the cables should be tightened. To tighten the cables,
first insert the weight pin into the middle of the weight
stack. Slack can be removed from these cables in
several ways:
See drawing A. Remove the M10 Nylon Locknut (111)
and the M10 x 50mm Bolt (106) from the indicated
Pulley (43), Cable Trap (48), Half Finger Guards (46),
and Pulley Plates (49). Reattach the Pulley, Cable
Trap, and Finger Guards using a hole closer to the
center of the Pulley Plates.
Make sure that the
Cable Trap is oriented to hold the cable in the
groove of the Pulley, that the Finger Guards are
oriented as shown, and that the Cable and Pulley
move smoothly. Adjust the top Pulley (43) in the
same manner, if necessary.
See drawing B. Adjust the Pulley (43) attached to the
Small Pulley Plate (50) as described above. To
remove more slack, tighten the M6 Nylon Locknut
(103) further onto the end of the Press Cable (72).
106
111
46
46
A
B
48
43
43
49
103
43
15
47