Filter
Top Products
16
26. During steps 26–53, see the PART IDENTIFI-
CATION CHART to identify the different types
o
f pulleys.
W
rap the Butterfly Cable (73) around a Pulley
(43). Attach the Pulley, a Cable Trap (48), an M10
Washer (109), and two Finger Guards (45) to the
Left Butterfly Arm (22) with an M10 x 50mm Bolt
(106) and an M10 Nylon Locknut (111).
Make
sure that the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
28. Wrap the Butterfly Cable (73) around a Pulley
(43). Attach the Pulley, a Cable Trap (48), an M10
Washer (109), and two Finger Guards (45) to the
Right Butterfly Arm (23) with an M10 x 50mm Bolt
(106) and an M10 Nylon Locknut (111). Make
sure that the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
29. Wrap the Butterfly Cable (73) under the “V”-pulley
(44).
Attach the “V”-pulley
, the Long Cable
Trap
(83), an M10 Washer (109), and two Finger
Guards (45) to the Right Upright (7) with an M10
x 150mm Bolt (94) and an M10 Nylon Locknut
(1
1
1).
Make sure that the Cable T
rap is orient
-
ed to hold the Cable in the groove of the “V”-
pulley.
27. Wrap the Butterfly Cable (73) around a Pulley
(43). Attach the Pulley, a Cable Trap (48), an M10
Washer (109), and two Half Finger Guards (46) to
the Right Upright (7) with an M10 x 120mm Bolt
(97), an M10 Washer (109), and an M10 Nylon
Locknut (111).
Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pulley
.
111
45
4
5
22
7
3
4
3
106
48
109
26
27
46
73
46
48
43
7
109
109
97
111
28
29
111
109
45
45
7
94
73
83
44
111
45
45
23
73
43
106
48
109