Filter
Top Products
Connect Frame to Tent
– Insert one Pole Tip into the grommet on the
webbing located at the corners of the tent (illus. 4).
– Go to opposite end of the same pole and
gradually apply pressure to the pole, forming an
arch, until you are able to insert the pole tip
into the grommet
– Attach the two Frame Clips at
the mesh vent to the pole
– Repeat for second pole
1
2
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door facing
desired direction. (illus. 1)
– For best results in windy conditions, postion
door or back of tent into the wind.
– Unzip door.
– Stake down tent corners. Keep the floor
taut.(illus. 2)
– Assemble Frame Poles by interlocking the
shock-corded sections. This will make two
long poles.
– Lay the poles out diagonally, centered on the
tent.The center of the poles should cross
forming an “X” in the middle of tent. (illus. 1)
– Fasten Toggle & Loop on top of tent over both
poles. (illus. 1), (illus. 3)
illus. 1
Toggle & Loop
illus. 2
Tent stake
through Loop
illus.4
Insert Pole Tip on
stake loop into pole.
illus. 5 Tent frame set-up
illus. 3
Toggle &
Loop
POLE ASSEMBLY PARTS
illus. 6
Frame Clips
aries
™
2
part number 9805-230
Main Tent Poles (2)
Part No. 9805-1101
Rainfly
Part No. 9805-1151