Coleman 2000004413 Tent User Manual


  Open as PDF
of 2
 
STITCH LINE
Fig. 10
Fig. 10
SHELTER SETUP INSTRUCTIONS
MODEL 2000004413
Before you begin
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your shelter.
WARNING: Keep clear of overhead power lines.
• Do not set up your shelter under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property
damage or personal injury.
• For best results in windy conditions, position narrow end of
shelter into the wind.
• Do not drop shelter.
• Do not bounce shelter bag on its end to remove shelter, as these
actions may damage the frame.
• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
• Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the
shelter frame.
Replacement Parts List
Description Part Number
(continued on other side)
Extend the Shelter Frame
Set up the Shelter
• With two persons standing at diagonal corners of the structure,
grab the leg, and pull out to unfold frame. (Fig. 1)
NOTE: Do not unfold frame completely. This will allow easier fit
for draping shelter top over frame.
• Drape shelter top over frame. (Fig. 2)
• Attach nylon fasteners, located on corners of shelter top, to six
corners of frame post. (Fig. 2A)
• Pull up sliding bracket located on upper
portion of leg until push button snaps into
place. (Fig. 3) This will ensure upper portion
of frame is fully extended.
• Secure shelter top to frame with nylon fasteners provided. (Fig. 4 & 5)
1
2
Fig. 5
Fig. 5Fig. 4
Fig. 1
HANDY TIP: To fully engage the
push button, grip the top and bottom
frame members and squeeze as
shown in Fig. 3A. Be careful to avoid
pinch points.
Fig. 3A
Fig. 3A
Install the Screen
• Unroll screen house and wrap around outside frame posts and
under the shelter top. Locate zippers per illustrations. (Fig. 8)
• Attach top of screen to frame with hooks and loops
provided. (Fig. 9 & 10)
NOTE: Shelter should be set at the highest
position when used with screen house.
4
Fig. 3
Push
Button
Zippers
Fig. 8
Push
Button
Upper
Portion
of Leg
Fig. 7
Shelter Top 5010000766
Fig. 9
Fig. 9
Fig. 2
2A
2A
Adjust the Height
• Adjust desired height until push button locks into place, making
sure all four posts are level. (Fig. 6 & 7)
3
Push
Button
Fig. 6