Filter
Top Products
STITCH LINE
HIGHLINE
TM
TENT 12’ X 12’ MODEL 2000001091
Before you begin
Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
• For best results in windy conditions, position end of tent into
the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface with
the door facing the desired direction. (Fig. 1)
2. Assemble all poles by interlocking the shock-corded,
sections together. (See components section above for
list of poles.)
3. Insert gray main poles through the sleeves on both
sides of tent; then insert black main poles through
sleeves, in front and back of tent. Make sure black poles
overlap the gray poles. (Fig. 1)
4. Insert end of each black & gray main pole into pins .
(Fig. 2 & 2A)
5. Go to opposite end of each pole and gradually apply
pressure to each forming arches. Insert the pin into each
pole end at the sides and corners of tent. (Fig. 2 & 2A)
6. Attach frame clips along edges of tent to the black &
gray main poles. (Fig. 2B)
7. Stretch tent until taut, then secure metal loops located
on both sides and corners of tent with stakes. (Fig. 2C)
Parts and Components
Description Part Number
Main Poles, Black (2) 5010000433
Main Poles, Gray (2) 5010000506
Vestibule Pole, Long, Thin, Black (1) 5010000507
Rainfly Ridge Pole, Thin, Black w/ Metal Tips (1) 5010000434
Rear Awning Pole (1) 5010000508
Rainfly 5010000435
To Attach Rainfly
1. Insert rainfly ridge pole with metal tips through sleeve
in underside of rainfly. (Fig. 3)
2. Drape rainfly over tent with rainfly ridge pole centered
from above front door to back of tent & the green
vestibule flaps located in the front. (Fig 4).
3. Insert rainfly ridge pole into metal grommet on front of
tent, apply pressure until pole forms an arch, then
insert other end into back grommet. (Fig. 4 & 4A).
NOTE: Because of the position of the center
grommets, it may be necessary to gently pull to
on the front & back arches for easier access.
4. Insert vestibule pole through sleeve in rainfly at front
of tent. (Fig. 4)
5. Locate all hook & loop fasteners on underside of
rainfly and wrap around black and gray poles to secure.
(Fig. 5)
6. Stretch elastic straps and hook clip on each to the
metal loops at the four corners of the tent. (Fig. 6)
Fig. 3
(continued on other side)
Fig. 1
Door
Gray, Main Poles
Side Sleeve
Fig. 2
Rainfly
Sleeve in Rainfly
Fig. 4
Metal Tip
Green Vestibule Flaps
2A
2B
Door
Thin, Black,
Rainfly
Ridge Pole
Black,longer,
Main Poles
Side Sleeve
Front & Back
Sleeves
4A
Door
Fig. 5 Fig. 6
2C
Sleeve in
Rainfly
Vestibule
Pole