Filter
Top Products
DURANGO
TM
15’ X 10’ MODEL 2000000143
STITCH LINE
Fig. 1
Fig. 7
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface with the
door facing the desired direction. Unzip door.
2. Stretch out corners and sides of tent. Secure with stakes
driven in at an angle to better anchor the tent. (Fig. 1 & 2)
Note: Staking the corners and sides will make it easier to
raise and tear-down the tent.
7. Insert one end of each black pole
into pins located on the ring in
center location at the back of the
tent. (Fig. 7)
8. Insert other end of black poles
into pins at front corners of tent;
and end of gray pole into pins on
sides of tent to form arches as
shown. (Fig. 8)
Fig. 8
Before you begin
Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
• For best results in windy conditions, position end of tent into
the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
Parts and Components
Description Part Number
Main Poles, Black (2) 9163-1051
Side Pole, Gray (1) 9163-1061
Roof Ridge Pole, Black (1) 9163-1071
Rainfly Pole, Black (1) 9163-1081
Rainfly 9163-1091
3. Assemble roof ridge pole (3-section, black, shock-corded
pole) and insert through sleeve in center of tent.
4. Place one end of roof ridge pole in brass grommet. Carefully
apply pressure on pole to allow other end of pole to bow and
be inserted into other brass grommet. (Fig. 3 & 4)
Fig. 2
Fig. 3
Fig. 4
5. Assemble the 2 long, black shock-corded poles and insert
through sleeves in top of tent forming an “X” as shown.
(Fig. 5)
Fig. 5
6. Assemble gray, shock-corded, side pole and insert through
sleeve in front of tent as shown. (Fig. 6)
Fig. 6
First
Black Pole
Gray
Pole
Gray
Pole
Second
Black Pole
9. Attach frame clips along tent seams to gray side pole and
both black poles. (Fig. 9 & 10)
Fig. 9
Fig. 10
To Attach Rainfly
1. Drape rainfly over tent. Make sure end with logo is centered
over the door and the rainfly seams are centered over the
gray and black
poles. (Fig. 11)
Fig. 11
(continued on
other side)