Coleman 14'x7' Camping Equipment User Manual


 
Connect Frame to Tent
– Locate the pin & ring systems on
either side of the front door and the
corresponding pin & rings on the back
side of tent.
– Insert one end of black frame pole
onto pin & ring system on tent stake
loop on either side of front door. (illus. 3)
– Go to opposite end of pole diagonally
from starting point and gradually apply
pressure to the pole forming an arch
until you are able to insert the pin into
pole end.
– Repeat for second pole.
– Attach tent frame clips to poles.
MONTANA
14’x7’
1
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door
facing desired direction. (illus. 1)
– Unzip door.
– Stake down tent corners, using the
tent stake loops. Keep the floor taut.
(illus. 2)
– Assemble all poles by interlocking
shock-corded poles.
– Insert the black poles into center pole
sleeves. The poles should cross
forming an “X” in the middle of tent.
(illus. 1)
2
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
– Do not set up your tent under trees.
For best results in windy conditions,
position the end of tent into the wind.
(2) Side Tent Poles
(Grey)
Rainfly Part No.
9279-349
(2) Main Tent Poles
(Black)
POLE ASSEMBLY PARTS
Front door
Instructions apply to Part Number 9279-197
illus. 1
illus. 2
Tent
stake through
stake loop
illus. 4
Center section upright
Part No. 9279-345
Part No. 9279-346
illus. 3
Pin & ring system located
on the front & rear of tent
Black poles
Black poles
(2) Rainfly Poles
Part No. 9279-348